GE WPRE6100 Technical Service Manual page 16

https://appliancetechmanuals.com
Control Panel
It is necessary to remove the control panel from the
backguard and place it in the service position to
access:
• Control circuit board
• Water level switch
• Water valve
• AC line filter
• ATC Thermistor
Caution: To prevent damage to the control panel,
place a protective pad on the cover/lid assembly.
To place the control panel in the service position:
1. Disconnect power.
2. Remove the four ¼-in. hex-head screws from
the rear of the control panel.
3. Gently pull out each top rear corner to unsnap
the control panel from the sides of the unit.
4. Rotate the top of the control panel forward
approximately 1 inch and slide to the right to
unlock the 3 bottom locking tabs.
5. Lift the panel up and off the cover panel and rotate
down.
Service Position
– 16 –
Tab