General Warnings; Delivery Content - Bresser F004514 Instruction Manual

Radio remote control for led photo studio lamps
Table of Contents

Advertisement

Available languages

Available languages

GENERAL WARNINGS

DANGER OF AN ELECTRIC SHOCK!
This device contains electronic parts that are powered by a power
source (batteries). Only use the device as described in the manual.
Otherwise, you run the DANGER of an ELECTRIC SHOCK.
Never attempt to operate a damaged device, or a device with dam-
aged electrical parts! Damaged parts must be replaced immediately
by an authorized service agent.
Operate the device only in a completely dry environment and do not
touch the device with wet or damp body parts.
1 PARTS LIST & DELIVERY CONTENT
Fig. 1
1.1 PARTS LIST
(-) Button
Decrease & Selection
(
) Power Button:
Power ON/OFF & Confirmation
(+) Button
Increase & Selection
(=) Menu
Power Output, Colour Temperature, Channel selection

1.2 DELIVERY CONTENT

2.4G Wireless Remote Controller (1x)
2 POWER SUPPLY
NOTE: This device is powered by 2 pcs. AAA Batteries.
3 INSTALLING THE BATTERIES
Open the battery compartment and insert 2 pcs. AAA batteries. Please
make sure that the + and - polarity is correct. Remove the batteries if
you don't use the remote for a long time.
FIRE/EXPLOSION HAZARD!
• Do not expose the device to high temperatures. Do not short-circuit
the device or dispose of in fire! Excessive heat and improper han-
dling can cause short circuits, fires and even explosions!
• Only use the recommended batteries
IMPORTANT NOTE!
Do not disassemble the device! In the event of a defect, please con-
tact your dealer. They will contact the Service Center and can arrange
the return of this device for repair if necessary.
Do not subject the device to excessive vibrations.
4 OPERATING AND USING THE DEVICE
POWER ON/OFF
Press the (
) Power button to switch the unit ON.
Long press the (
) Power button to switch the unit OFF.
CYCLE THROUGH THE MENU
(=)
Press the
Menu button to cycle through the menu.
Press 1x = shows 10 "power output" 10 = 10%
Press 2x = shows 56 "color value"
Press 3x = shows 01 "channel"
SELECT THE CHANNEL
(=)
Press the
Menu button 3 times to go to the channel menu.
(+)
(-)
Press
or
to choose your desired channel.
(=)
Press the
Menu button to confirm your selection.
!
1
56 = 5600 K
01 = Channel 1

Advertisement

Table of Contents
loading

Table of Contents