Sharp VC-A415U Service Manual page 26

VC-A415U/H815U
VC-H817U/H818U
4-23. INSTALLING THE SHIFTER
Capstan
D.D. motor
Reel pulley
(Bottom side of mechanism chassis)
Drum
Figure 4-42.
Insert
point 3
Insert
point 2
Phase-matching
point 1
1. Make sure that the loading gear is at the Phase-Match-
ing point 1 as shown below.
2. Install, paying attention to insert point 5 and release
point 3.
3. For the phase matching at the insert point 1, see the
Phase-Matching point 2 as shown below.
4. Finally fix the inserts 1 and 4.
Phase-Matching
point 2
Loading gear (T)
Round mark
Sifter
Half round notch
Insert
point 4
Shaft 1
Rotation
point 2
Shaft 4
Release
point 3
Shaft 1
Figure 4-43.
28
Insert
point 1
Shaft 1
Insert
point 5