Advertisement
Quick Links
Advertisement
Related Manuals for TELink B91
Summary of Contents for TELink B91
- Page 1 Demo Quick Start Guide Telink Thread Telink Proprietary...
- Page 2 Hardware B91 Development board Telink Proprietary...
- Page 3 Hardware Telink Burning Board Use USB to connect PC and the Telink Burning Board, when the LED is off, the connection is successful. There is no need to install the driver. Use dupont wire to connect and DUT. Telink Burning Board 3V3 ->...
- Page 4 USB to TTL serial cable Connect the DUT and USB-TTL together. TXD -> PB3 (DUT) RXD -> PB2 (DUT) GND -> GND (DUT) Refer to “Burning and Debugging Tools for all Series” to download the binary file to the board. Telink Proprietary...
- Page 5 Form Thread Network Take forming two nodes network as example , power on the node A and run the following commands: panid 1111 Telink Proprietary...
- Page 6 Form Thread Network channel 12 Telink Proprietary...
- Page 7 Form Thread Network ifconfig up Telink Proprietary...
- Page 8 Form Thread Network thread start Telink Proprietary...
- Page 9 Form Thread Network state Now we know that node A has become the Leader. Telink Proprietary...
- Page 10 Form Thread Network Power on the node B, run the same commands as node A, we can see that first the node B becomes to the child, then change to the router after a few seconds: Telink Proprietary...
- Page 11 Form Thread Network Use the command “ipaddr” to get the IP addresses of node A. Telink Proprietary...
- Page 12 Form Thread Network Run the “ping” command on the node B, we can see that the node B receives the reply message from node A. Telink Proprietary...