Porter & Charles CI60V Quick Start Manual

Quick Start Guide
Upper left
Increase
heater selection
heat setting/
Heater
timer(optional)
Display
Smart Pause
Decrease
lower left
heat setting heater selection
/ timer(optional)

Starting cooking :

1- At first plug-in, touch on/off key.
2- Touch the "heater selection key" corresponding to the zone (placed a
cookware). The red blinking dot of the selected zone will become static,
and the other dots will disappear. (Place a suitable cookware on the
cooking zone for activating the heater.)
3- Set the heating level by pressing (+) or (-) buttons.

Stop cooking :

1- Touch the corresponding zone "heater selection key".
2- Touch (+) and (-) buttons simultaneously, to switch off the zone. Or set
the heating level to (0) by touching (-) button.
3- If you touch "ON/OFF" key, all zones will be switched off.
4- If timer is available on the hob, press timer function button to switch off
the heater.
Timer
Display
Upper Right
heater selection
Key Key Lock
Lock
Indicator
Boost On/Off
Lower Right
heater selection
Timer
Hot surface warning ( H ) :
When the zone is switched off, "H" (hot surface) warning symbol will
appear in display, if there is a residual heat on the cooking zone. Even if the
appliance is switched off, H will not disappear until the hob cools down.

(BOOST) function :

All heaters are equipped with boost function.
1- Place a cookware on a heating zone and select the zone from its button.
Set the heating level and then press (P) key. "P" symbol will begin to flash
intermittently with heating level
NOTE: The temperature level can be changed during heat-up.
2- To cancel boost mode, press (P)

Child lock :

When the hob is at standby mode ; the mains power is on, but all heater
displays are off ( or a residual heat display "H" is active)
To activate child lock ;
1- Press ON/OFF key until a buzzer beep signal is heard.
2- Then touch (+) and (-) buttons simultaneously for
maximum 1 second.
3- Following this, the child lock can be activated by touching (+) button. All
heater displays will show "L" when child lock is active.
EN