Table of Contents
Advertisement
Problem
Other
The wrong date and
time are displayed,
or the wrong date
and time are being
stored along with
image data.
The messages on
the display are in
the wrong language.
Language selection
screen appears
when the camera
and controller are
turned on.
There are various
indicators and
values on the
monitor screen.
Buttons are not
responsive right
after the power has
been turned on.
Images are not
displayed.
Possible Cause and Recommended Action
The date and time setting is off. Set the correct date and time
(page 66).
The wrong display language is selected. Change the display
language setting (page 67).
1)You did not configure initial settings after purchasing the
camera or the camera may have been left with a dead
battery. Check the camera setup (pages 21, 66).
2)There may be a problem with the camera's memory data. If
this is the case, perform the reset operation to initialize the
camera's setup (page 68). After that, configure each setting.
If the language selection screen does not re-appear when
you turn the camera on, it means that the camera's memory
management data has been restored.
If the same message appears after you turn power back on,
contact your retailer or a CASIO authorized service center.
The monitor screen shows indicators and other information
about shooting conditions and the image you are recording.
You can hide display information, if you want (page 11).
With large capacity memory cards there is a delay after the
power has been turned on before the buttons become
responsive.
1)The camera is turned off.
2)There is no Bluetooth connection between the camera and
controller (page 23).
93
Appendix
Advertisement
Table of Contents
