Using Additional Handsets; Easy Registration Of A New Additional Inspire Handset - BT INSPIRE 1500 User Manual

Using additional handsets

You can use up to five BT Inspire additional handsets with your BT
Inspire 1500 base to extend your phone system without needing
to install extension sockets for each new phone.
Your BT Inspire 1500 handset can also be registered to up to four
other bases. You can then select the base you would prefer to use.
If you have purchased a BT Inspire 1500 multiple pack any
additional handsets come pre-registered to the base.
If you have purchased an additional handset you must register it
to your BT Inspire 1500 base before it can be used. The batteries
must be fully charged for 24 hours before you register it.
You may be able to register other DECT handsets to your BT
Inspire 1500. Compatibility of products may vary and the number
of features available may be reduced in doing so.

Easy registration of a new additional Inspire handset

To use easy registration a new handset must be used and the
base must have the PIN code 0000. (If the base PIN has been
changed then the longer registration procedure on the following
page will need to be followed).
1. The display will show
has been fully charged for 24 hours, press
2. The display will show
Press and hold the
8 seconds until the base beeps, then release.
3. Immediately, press
go into registration mode for 90 seconds and will beep when
registration is successful. The handset will automatically be
assigned the next available handset number and registration is
now complete.
If you experience any problems, please call the Helpline on Freephone 0800 218 2182* or email bt.helpdesk@vtecheurope.com
and once the handset
Please Register
Press and Hold Base Find Key
button on the base for approximately
on the handset to confirm. The base will
OK
(left soft key).
Reg
.
Registration of handsets can only take
place while the base is not engaged
on another call.
If registration is not successful first
time, please repeat the process again
in case the base registration period
ran out of time.
If there are already 5 handsets
registered to the base, the
registration will fail. You must
de-register another handset before
you can register the new one.
If your BT Inspire 1500 handset is
registered to more than one base,
you can select which base to use,
see page 25.
If you have a handset registered
to more than one base and then
de-register it from one of them
you will need to re-select which
base to use. Until the base is
selected the handset will display
.
Please Register
46