Table of Contents
Advertisement
3. Keep the small spring attached to
the copper pillar and place the
compressed spring back into the
bottom of the assembly. Note: The
compressed spring will have the
small end facing outward
4. Place new battery cells back into
the assembly with negative (-) pole
facing upwards and positive (+)
facing towards the compressed
spring. Move the round copper
cover plate to cover and touch the
button cell.
5. Insert the small spring back into the
pocket of the upper cover and press
the upper cover into place to
complete the installation.
If you have any questions regarding the previous procedure, please contact our technical department
Monday-Friday from 8:30 AM-5:00 PM PST at 877-338-0999.
If you have any questions, please contact Champion Power Equipment:
Champion Power Equipment, Inc.
12039 Smith Ave.
Santa Fe Springs, CA 90670
Phone: 1-877-338-0999
Email: tech@championpowerequipment.com
11/29/18
2
Champion Power Equipment, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the 100306 and is the answer not in the manual?
Questions and answers