Panasonic YD-350FD2 Operating Instructions Manual page 26

Double pulse
P19
(MUP) enabled
※5 Double pulse: In the original pulse (high pulse part), based on the increase in the low pulse part.c
【INIT·CRATER】
NO. Menu contents
CRATER
P06
REPEAT
CRATER
P07 REPEAT
TIME
Crater linkage
P14
percentage
INIT linkage
P13
percentage
INIT·CRATER
P27
Switch
【Others】
NO. Menu contents
P24 Arc shape
Welding display
P25
mode
0 1 or 2 1
Set range Increment
0 or 1 1
0 s～5 s 1 s
0～200 1
0～200 1
0 or 1 1
Set range Increment
-99～99 1
0 or 1 1
Settings
0
Default
0
The setting of the value of the time of
2 s
NOT 0: The arc current is [Welding current]
* [Setting value] %; 0: The closing arc
current is the setting of [Arc current value].
0 Note: After the linkage percentage is set,
the arc current does not exceed the
maximum welding current limit [350 A /
Not0: Initial current is [Welding current] *
0: Initial current is the set [Initial current
0
Note: After the linkage percentage is set,
the initial current will not exceed the
maximum value of the welding current [350
0
Default
The higher
0 concentrated arc you get ； The lower, the
less concentrated arc.
0 stands for current and voltage display ;1
0
stands for energy display [P=U*I].
23
0: normal pulse
1:double pulse
2:pulse + Short circuit
Note
1: enabled, 0: disabled.
Chapter 8）
（
closing arc repeating.
500 A]
[Setting value] %;
value].
A / 500 A]
1：AUTO 0：Manual
Note
value you set, the more