Advertisement
Available languages
Available languages
WARNING! When using electric tools, basic
safety precautions should always be followed
to reduce the risk of fire, electric shock and
personal injury.
1.
Work environment should be clean, dry, well lit and
clear of flammable materials.
2. Do not use outdoors or near water.
3. Do not expose gun to rain, moisture or direct sunlight.
4. Keep away from children and store locked up when
not in use.
5. Do not carry gun by cord or unplug from outlet by
pulling electrical cord.
6. Disconnect gun when not in use.
7.
Do not leave gun unattended.
8. Do not use hot melt glue to replace structural
fasteners.
OPERATING ISSUE
Glue gun will not heat up.
Gun will not feed.
PAGE 2 OF 6
SAFETY
9. Do not use extension cords.
10. Avoid accidental discharge. Do not touch glue stick
11. Allow glue gun to cool before storing.
TROUBLESHOOTING
RECOMMENDATIONS
Make sure glue gun is plugged into a 120V electrical outlet.
Glue sticks may be too small in diameter or too soft formula.
Use only recommended stick sizes and formulas.
When trigger is continuously applied or internal temperature
is reduced, feed will be paused. Wait 30 seconds for gun to
recover, and then pull trigger.
1-800-295-5510
uline.com
or trigger except to dispense glue.
CAUTION! Do not touch heated glue gun nozzle
or melted glue; temperature can reach 380ºF.
If accidental contact occurs, do not remove
glue. Immediately put burned area into cold
water. Contact doctor right away. Always wear
protective clothing including: safety glasses,
gloves, long sleeve shirt and long pants. Keep
away from flammable materials.
NOTE: Do not elevate front of glue gun or lay on
side. Always use on attached stand.
NOTE: Uline assumes no responsibility for
consequential or indirect damages from
the use of this product.
0421 IH-7182
Advertisement
