Sony CYBER-SHOT DSC-RX10 Help Manual page 166

Battery capacity decreases over time and through repeated use. If

decreased usage time between charges becomes significant, it is probably
time to replace it with a new one.
The charge lamp on the product flashes when charging battery pack.
Make sure that the battery is NP-FW50.

When you charge a battery pack that has not been used for a long time,

the charge lamp on the product may flash in rare cases. If this happens,
remove the battery pack and re-insert it.
The battery pack has not been charged even if the charge lamp on the
product has turned off.
This phenomenon occurs when you charge the battery pack in an extremely hot
or cold location. The optimum temperature for charging the battery pack is
between 10 °C and 30 °C (50 °F and 86 °F).
The battery pack is not charged.
When the battery pack is not charged (the charge lamp does not light) even if
you follow the proper charging procedure, remove the battery pack and re-insert
the same battery pack securely, or disconnect and reconnect the USB cable.
Shooting still images/movies
You cannot record images.
You are using a memory card with a write-protect switch, and the switch

is set to the LOCK position. Set the switch to the record position.
Check the free capacity of the memory card.

You cannot record images while charging the flash.

Recording takes a long time.
The noise reduction function is processing an image. This is not a

malfunction.
You are shooting in RAW mode. Since RAW data files are large, RAW

mode shooting may take time.
The [Auto HDR] function is processing an image.

The product is compiling images.

The image is out of focus.
The subject is too close. Shoot from the shortest shooting distance (W

side: Approx. 3 cm (1.2 inches), T side: Approx. 30 cm (0.99 ft (from the
lens)).
All manuals and user guides at all-guides.com
166