Troubleshooting - Bosch MCM 5000m Owner's Manual

TROUBLESHOOTING

Problem
Power
unit does
not
function
Rotary switch
will not turn
Power
unit hums
but
nothing is
moving
Possible Cause
1.A circuit breaker may have
tripped or a fuse has blown
in the power supply circuit.
2.Safety motor drive cover is
not in place on high speed,
blender drive, when dual
drive is being used.
3.The built-in safety cutout
may have tripped.
1.Safety cover interlock is not
engaged.
1.The motor has become
blocked; that is, the
attachment being used has
become jammed.
Remedy
Reset circuit breaker or
replace fuse.
Place safety motor drive cover on
high speed blender drive.
If the safety has tripped due to
overheating:
> Turn the power unit to the Off
position, "O/Off," and unplug.
> Remove the attachment that was
in use when safety tripped, and
correct whatever the situation
is that caused the safety to trip.
> Contact Bosch Small Appliances
Customer Support, see page 22,
for closest Bosch authorized
service center.
> Take, or ship, the food processor
to a Bosch authorized service
center to have the safety cutout
replaced.
Safety cover interlock must be
engaged before rotary switch can
be turned. Rotate bowl cover or
juicer tab clockwise until interlock
tabs clicks into place.
> Turn the power unit to the Off
position, "O/Off," and unplug.
> Remove
that was in use and correct
whatever the situation is that
is causing the blockage.
> Reinstall the attachment and
resume use per attachments
instructions.
23
the attachment