Hitachi RASM-2VRE Installation And Setup page 10

After setting the heat pump up then the final task before testing the heat pump is to enter
your details so the customer can contact you if there is a problem.
In Installer Mode go back to the Main Menu, scroll down to ABOUT then select CONTACT
INFORMATION. You can then enter your name and phone number one character at a time.
Your system is now Fully Set up and Ready for Test Run
Before Test Run please ensure that
1. Power has been ON to the outdoor unit for at least 8 hours
2. All shut off valves are open. Including the ones you had forgotten about!
3. All auto air vents are open and the three port valve is in auto mode
4. The room thermostat is switched OFF
Important Note—Using a Hitachi Thermostat, wired or wireless
This manual is based around the use of a third party RF programmable controller NOT a Hi-
tachi wired or wireless controller. If you are going to use a Hitachi controller then please con-
tact Secon Solar Technical as the wiring schematic and setup procedure are different to that
shown in this manual.
Important Note—Using a Mirror Box
If you are using a mirror box please contact Secon Renewable
Technical
We have an additional manual for use with this item
T: 0191 516 6554
Your details
W: www.seconrenewable.com
Enter your
details
E: info@seconrenewables.com