Turn On; Set Clock; Demonstrate The Unit's Features; Store Radio Stations Automatically - Philips MCM2000 User Manual

Turn on

Press .
» The unit switches to the last selected
source.
Switch to standby mode
Press for over 3 seconds to switch the unit to
Eco Power Standby mode.
» The backlight on the display panel turns off.
To switch the unit to standby mode:
In Eco Power Standby mode, press
3 seconds.
» 7KH FORFN LI VHW DSSHDUV RQ WKH GLVSOD\
panel.

Set clock

1
In standby mode, press PROG/CLOCK
SET for 3 seconds to activate clock setting
mode.
» [CLOCK SET] scrolls on the display,
then the time format [24H] and [12H]
appears.
2
Press / RU 92/  WR VHOHFW + RU
12H, then press PROG/CLOCK SET to
FRQÀUP
» The hour digits begin to blink.
3
Press / to set hour, then press
PROG/CLOCK SET again.
» The minute digits begin to blink.
4
Press / to set minute.
5
Press PROG/CLOCK SET WR FRQÀUP WKH
clock setting.
Note
‡
To exit clock setting mode without storing, press
‡
If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
All manuals and user guides at all-guides.com
for over
.
Demonstrate the unit's
features
In the standby mode, press
ON" is displayed.
» This system's features are displayed one by
one.
‡ To turn off the demonstration, press
again.
Store radio stations
automatically
If no radio stations are stored, the unit can store
radio stations automatically.
1
Turn on the unit.
2
Press RADIO.
» [AUTO INSTALL -- PRESS PLAY --
STOP CANCEL] (press
automatic installation, or press
FDQFHO LV GLVSOD\HG
3
Press .
» 7KH UDGLR VWDWLRQV ZLWK VXIÀFLHQW VLJQDO
strength are stored automatically.
» After all available radio stations are
VWRUHG WKH ÀUVW VWRUHG UDGLR VWDWLRQ
broadcasts automatically.
until "DEMO
to start
to
EN 11