Vcr Setup - LG 32LX4DC Owner's Manual

Installation
NOTE: All cables shown are not included with the TV.
- To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
- Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides
of the screen may remain visible on the screen.
When connecting with an antenna
TV Back
DVI INPUT
(PC/DTV INPUT)
S-VIDEO
AUDIO VIDEO
R L/MONO
VIDEO1
COMPONENT1
R L
Antenna
AUDIO INPUT VIDEO INPUT
When connecting with a RCA cable
TV Back
DVI INPUT
(PC/DTV INPUT)
S-VIDEO
AUDIO VIDEO
R L/MONO
VIDEO1
COMPONENT1
R L
AUDIO INPUT VIDEO INPUT
1
ANT IN
ANT OUT S-VIDEO OUT
(R) AUDIO (L) VIDEO
OUTPUT
SWITCH
3 4 IN
When connecting with an S-Video cable
TV Back
DVI INPUT
(PC/DTV INPUT)
S-VIDEO
AUDIO VIDEO
R L/MONO
VIDEO1
COMPONENT1
R L
AUDIO INPUT VIDEO INPUT
1
ANT IN
S-VIDEO OUT
ANT OUT
(R) AUDIO (L) VIDEO
OUTPUT
SWITCH
3 4 IN
18
All manuals and user guides at all-guides.com

VCR Setup

2
ANT IN
S-VIDEO OUT
ANT OUT
(R) AUDIO (L) VIDEO
OUTPUT
SWITCH
3 4
IN
VCR
1
Antenna
VCR
Antenna
2
VCR
Connect the RF antenna out socket of the VCR to
1
the Antenna socket on the set.
Connect the antenna cable to the RF antenna in
2
socket of the VCR.
Set VCR output switch to 3 or 4 and then tune TV
3
to the same channel number.
Insert a video tape into the VCR and press PLAY
4
on the VCR. (Refer to the VCR owner's manual.)
Connect the AUDIO/VIDEO jacks between TV
1
and VCR. Match the jack colors (Video = yellow,
Audio Left = white, and Audio Right = red)
Insert a video tape into the VCR and press PLAY
2
on the VCR. (Refer to the VCR owner's manual.)
Select AV 1 input source with using the INPUT
3
button on the remote control.
- If connected to IN 2 input (TV front), select AV 2
input source.
• If you have a mono VCR, connect the audio cable
from the VCR to the AUDIO L/MONO jack of the set.
Connect the an S-VIDEO output of the VCR to the
1
S-VIDEO input on the set. The picture quality is
improved; compared to connecting a regular VCR
to the Video input.
Connect the audio outputs of the VCR to the
2
AUDIO input jacks on the set.
Insert a video tape into the VCR and press PLAY
3
on the VCR. (Refer to the VCR owner's manual.)
Select AV 1 input source with using the INPUT
4
button on the remote control.
- If connected to IN2 input (TV front), select AV 2
input source.
Do not connect to both Video and S-Video at
the same time.