Sanyo EM-CD2900UK Service Manual page 17

E. E. E. E. E.REMOVING CONTROL CIRCUIT BOARD REMOVING CONTROL CIRCUIT BOARD REMOVING CONTROL CIRCUIT BOARD
REMOVING CONTROL CIRCUIT BOARD REMOVING CONTROL CIRCUIT BOARD
(1) Disconnect all connector and lead wires from
the control circuit board.
(2) Remove 2 screws securing the tabs for earthing
to the oven cavity.
(3) Remove 2 screws securing the control panel as‑
sembly to the oven cavity.
(4) Push up and then pull out the control panel
assembly.
(5) Disconnect all lead wires of the control panel
from the control PCB.(S105,S106,S102,S1 con‑
nector for the relay PCB)
F. F. F. F. F.REMOVING TOUCH KEY BOARD AND TIME CONTROLLER REMOVING TOUCH KEY BOARD AND TIME CONTROLLER REMOVING TOUCH KEY BOARD AND TIME CONTROLLER REMOVING TOUCH KEY BOARD AND TIME CONTROLLER
REMOVING TOUCH KEY BOARD AND TIME CONTROLLER
After removing control circuit board;
(1) Pull the control knob out.
(2) Remove 4 screws securing the control panel
assembly to the cavity and the FPC connector
from the connector S101 while pushing up the
end of the plastic fastener.And pull the connec‑
tor out from S104. (Figure 11)
(3) Insert a thin flat blade screwdriver between
the cover assembly and control base and release
the hook one by one. (Figure 12)
(4) Remove the touch key board which is held on the
control base with the adhesive tape from the
front of the control base. (Figure 13)
(5) Remove the adhesive tape from the front of the
control base completely.
G.REMOVING CERAMIC TRAY ASSEMBLY G.REMOVING CERAMIC TRAY ASSEMBLY G.REMOVING CERAMIC TRAY ASSEMBLY
G.REMOVING CERAMIC TRAY ASSEMBLY G.REMOVING CERAMIC TRAY ASSEMBLY
(See exploded view on page 23)
(1) Take off the cabinet and frame rear plate
assembly.
(2) Put (insert) a screwdriver in the 9 mm dia‑
meter hole locating at back side of the
oven cavity.
And push the tray up with the screwdriver.
(Figure 14)
(3) Open the door and take out the tray very
carefully.
Figure 14
‑ 16 ‑
Figure 11
Release the hook one by one
Figure 12
Remove the touch key board from
the front of the base
Remove 4 screws
and FPC connector
Figure 13