Advertisement
Signal (＋) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
Operating Modes: You can use the fixture in 3 ways:
⚫
Auto Mode - The unit will automatically chase through the different colors and built-in programs.
⚫
Slave Mode – The unit will run under slave mode.
⚫
DMX control mode - This function will allow you to control each individual fixtures traits with a standard DMX 512 controller.
⚫
DMX Mode: Operating through a DMX controller give the user the freedom to create their own programs tailored to their own individual
needs. This function also allows you to use your fixtures as spot lights.
This function will allow you to control each individual fixture's traits with a standard DMX 512 controller.
1.
The fixture has 16/24 two DMX channels to operate. Please see "DMX Values and Functions" for the DMX traits.
2.
3.
To run your fixture in DMX mode, plug in the fixture via the XLR connections to any standard DMX controller. Set your desired DMX
address following the setup specifications that come with your DMX controller.
Hanging Drawing:
CAUTION!
Use an appropriate clamp to ring the fixture on the truss.
Follow the instructions mentioned at the bottom of the base.
Make sure that the device is fixed properly! Ensure that the structure (truss) to which you are attaching the fixtures is secure.
Securing the fixture via one safety wire
Securing the fixture via two safety wires
4
Advertisement
