Advertisement
1
Assembling the Scary Clown Arch
NOTES: Place the six (6) sections of the Scary Clown
Arch(A,B,E,F,G,H) face down on the ground or floor. Attach the
connecting rods into the connecting holes for each Scary Clown Arch
Section (A,B,E,F,G,H) per the diagram below. A & B connect, B & E
connect, E & F connect, F & G connect, G & H connect. Tuck the
power cord that runs throughout the parts into the sections so it is
not visible on the outside.
E
F
G
H
3 Assembling the Left and Right Section of Hairs
Insert the connecting rods on the Left and Right Section of Hairs
(C,D) into the connecting holes on the Left and Right Section of
Heads (E,F).
E
F
D
5 Attach the Stabilizing Bars to the Arch and Base Stands
Insert the connecting rods on the bottom of the Scary Clown Arch
sections (A, H) into the matching holes of the Base Stands (L). Insert
the connecting rods on the upper Stabilizing Bars (J) into the matching
connecting holes on the back of the Arch Sections (B,G) then secure
with the Cotter Pins (O). Insert the connecting rods on the lower
Stabilizing Bars (K) into the left and right Base Stands (L) then secure
with the Cotter Pins (O).
L
J&K
G
H
7 Assembling the Red Nose
Insert the connecting rods on the Red Nose (I) into the matching holes
on the front of the Right Section of Head (E) then fasten them (E,F,I)
together at the connecting loops with the Plastic Tie (P).
E
I
ASSEMBLY
B
A
C
J&K
B
L
A
O
F
P
2
Securing the Assembled Scary Clown Arch
Align the connecting loops between the sections (per the diagram below)
with each other and fasten the sections of the Scary Clown Arch
(A,B,E,F,G,H) together at the connecting loops with the Plastic Ties (P).
F
G
H
4 Assembling the Stabilizing Bars
Attach the sections of the Stabilizing Bars (J,K) together and lock with built
in locking pin.
J
K
6
Stand up the Arch
Stand the assembled Scary Clown Arch up to an upright standing
position.
8 Attach the Anchoring Strings and Ground Stakes
Insert Ground Stakes (R) over the 4 corners of the Left and Right Base
Stands then press into the ground. The Arch comes with Anchoring Strings
(Q). Hook the plastic clip end of each Anchoring Strings (Q) onto the
securing loop located on the Middle Left and Right Sections of Section of
Arch (B,G). Use the remaining Ground Stakes and run the looped end of
the Anchoring Strings over the clip on the end of the Ground Stake. Pull
the Anchoring Strings with Ground Stakes away and out from the Arch in
four directions then press the Ground Stake (R) firmly into the ground.
B
E
B
P
G
Q
R
R
A
Advertisement
