E-Z-RECT TRIM-LINE Assembly Instructions

TRIM-LINE Boltless Shelving
WARNING:
PLEASE FOLLOW ASSEMBLY INSTRUCTIONS. DO NOT USE SHELVES OR CONNECTORS WITH COMPONENTS OTHER THAN E-Z-RECT PRODUCTS.
POST
CONNECTOR
POST
SCREWDRIVER OR
CHAINSAW WRENCH
F R A M E A S S E M B L Y
S T E P O N E
Place post flat on the ground so that Post Connector
slots are on the inside and the seam is on the outside.
Post Connectors are adjustable as illustrated on the
back page of the assembly instructions and are
required for end frame assembly.
CAUTION
– P O S T C O N N E C T O R M U S T B E L O C K E D F O R S AF E T Y
NOT LOCKED
SH E LF P L AC EM E NT
–
L A Y T H E S H E L F O N T O P O F F R A M E C O N N E C T O R
ON TOP PLACED
LOCK
SAFETY
FIFTH
TWIST LOCK
LOCK
THIRD
LOCK
FIRST
S T E P T W O
Starting from the bottom tap in one side of the Post
Connector and LOCK IMMEDIATELY. Then tap in and
lock the other side. The post will have to be spread
lightly as you work your way up the post. Use a 1/4" or
a 3/8" screwdriver or chainsaw wrench to lock
connectors. Assembly time is approximately 1 to 2
minutes per 84" (2134mm) frame.
LOCKED TAB FULLY LOCKED
CORRECT INCORRECT
Maximum Evenly Distributed Static Load
Load Per Pair of Connectors
LOCK
Capacities
36" 39 1/2" 48"
SIXTH
0.91m 1.00m 1.22m
4 Shelf Clips
350 lb 290 lb 200 lb
& one Metal
159 kg 132 kg 91 kg
20ga. Shelf
390 lb 350 lb 290 lb
TFC
177 kg 159 kg 132 kg
600 lb 550 lb 500 lb
TBC
272 kg 249 kg 227 kg
700 lb 675 lb 650 lb
TWB
318 kg 306 kg 295 kg
TWB with one
975 lb 950 lb 925 lb
Combination
442 kg 431 kg 420 kg
Tie Bar
LOCK
Please note load capacities & components subject to change without notice.
FOURTH
SAFE WORKING LOADS OF UP TO 7,000 LBS (3,175 kgs) PER PAIR
OF POSTS OR BAY OF SHELVING.
SAFETY FACTOR OF 1.66 TO 1.00 BASED ON MINIMUM YIELD
STATIC LOADING ONLY.
PLEASE CONTACT THE FACTORY FOR CAPACITIES NOT SHOWN
LOCK
IN CHART.
SECOND
BLACK PLASTIC CAP
BLACK PLASTIC
FLOOR PROTECTOR
BLACK PLASTIC ZINC PLATED
STACKABLE SHIM FLOOR PROTECTOR
E-Z-RECT MANUFACTURING LTD.
Head Office: North Vancouver, P: 604 929 5461 Eastern Sales: Mississauga, P: 905 564 0890
Email: sales@ezrect.ca Web: www.ezrect.ca Email: torontosales@ezrect.ca
Assembly Instructions
ONLY FOUR BASIC COMPONENTS
1. Post
2. Post Connector
60" 66" 72"
1.52m 1.68m 1.83m
- - - - - -
- - - - - -
191 lb - - - -
87 kg - - - -
- - - - - -
- - - - - -
POST
550 lb 450 lb 375 lb
249 kg 204 kg 170 kg
900 lb 800 lb 700 lb
408 kg 363 kg 318 kg
SHELF CLIPS
4 Required per shelf level
(2 Right Hand & 2 Left Hand)
Used for metal shelves.
WIDTH
2' TO 6'
CONNECTOR LOCKING CLIP
Simply snap in connector
locking clip where/when
TRB GARMENT ROD SUPPORT
required to lock connector.
Use to support 1" O.D. galvanized garment hang rod.
Available depths: 12" (0.30m), 15" (0.38m),
18" (0.46m), 24" (0.61m),
TFCV FRAME CONNECTOR
30" (0.76m), 36" (0.91m).
Use with particleboard shelves.
Available lengths: 36" (0.91m),
39 1/2" (1.00m), 48" (1.22m).
TFCL FRAME CONNECTOR
Use with metal shelves.
Available lengths: 36" (0.91m),
COMBINATION TIE BARS
39 1/2" (1.00m), 48" (1.22m).
Use with TWB connectors.
Available depths: 18" (0.46m), 24" (0.61m),
30" (0.76m), 36" (0.91m).
TBC FRAME CONNECTOR
Allow TCTB hook to snap into connector
Use with metal or particleboard shelves.
slot with its own spring.
Available lengths: 36" (0.91m),
39 1/2" (1.00m), 48" (1.22m).
TWB FRAME CONNECTOR
Use with metal or particleboard shelves
and as a kickplate.
POST CONNECTORS
Available lengths: 36" (0.91m),
Use to join posts (refer to chart for quantity).
39 1/2" (1.00m), 48" (1.22m),
60" (1.52m), 66" (1.68m), 72" (1.83m). Available depths: 12" (0.30m), 15" (0.38m),
18" (0.46m), 24" (0.61m),
30" (0.76m), 36" (0.91m).
ZINC PLATED
SHIM
UK Sales: Oxon, P: 01993 779494
Web: www.ezrect.ca Email: mail@ezrshelving.com
3. Frame Connector.
4. Shelf (metal or particle board)
PLASTIC CAP
FRAME
CONNECTOR
HEIGHT
3' TO 20'
SHELF
POST
CONNECTOR
DEPTH
1' TO 3'
Web: www.ezrshelving.com
© E-Z-Rect Manufacturing Ltd. TL Revised October 2019