Advertisement
Quick Links
Trail Rocker Installation
Instructions
WINCH CONTROL ADD-ON KIT
For Installing Painless Part Number: 57150
Manual #90619
Painless Performance Products recommends you, the installer, read this installation
manual from front to back before installing this harness.
1
Advertisement
Related Manuals for Painless TRAIL ROCKER 57150
Summary of Contents for Painless TRAIL ROCKER 57150
- Page 1 Trail Rocker Installation Instructions WINCH CONTROL ADD-ON KIT For Installing Painless Part Number: 57150 Manual #90619 Painless Performance Products recommends you, the installer, read this installation manual from front to back before installing this harness.
- Page 2 E-Mail: painless@painlessperformance.com If you have any questions concerning the installation of this product, feel free to call Painless Performance Products' tech line at 1-800-423- 9696. Calls are answered from 8am to 5pm central time, Monday thru Thursday, 8am-4:30pm Friday, except holidays.
-
Page 3: Installation
INSTALLATION As part of your Trail Rocker Switch Panel wiring harness, there are 2 optional winch control wires: a WHITE/RED (IN) and a BROWN/WHITE (OUT). These wires control the in and out functions of a winch when it is installed. The following steps show you how to install a Winch Control Add-on Kit to your Trail Rocker Switch Panel and connect the control wires to the switch. - Page 4 Step 1: Remove the switch control, power, and ground wires from the switch you are replacing with the Winch Control Add-on Kit. Then, locate the tabs located at the top and bottom of the switch. Step 2: These tabs lock the switch in place. To remove the switch, squeeze the tabs in and slide it out of the bracket.
- Page 5 Step 3: Insert the Winch Control Add-on Kit into the empty socket of the bracket. Step 4: Before connecting the wires to the Winch Control Add-on Kit, take time to familiarize yourself with the wiring diagram below.
- Page 6 Step 5: Reconnect the power, ground, and control wires to the Winch Control Add-on Kit as seen below.
- Page 7 OPTIONAL: WINCH PIGTAIL If you are hooking up your winch to your Trail Rocker System, read the following steps for attaching the included winch pigtail. Step 6: Locate the winch pigtail included in your parts kit. Then locate the winch connector on your Fuse/Relay Center. Step 7: Remove the cap from the winch connector on the Fuse/Relay Center.
- Page 9 Chassis harnesses, fuel injection harnesses, and Trail Rocker units are covered under a lifetime warranty. All other products manufactured and/or sold by Painless Performance are warranted to the original purchaser to be free from defects in material and workmanship under normal use. Painless Performance will repair or replace defective products without charge during the first 12 months from the purchase date.
- Page 10 Painless Performance Products LLC 2501 Ludelle Street Fort Worth, TX 76105 Phone (817) 244-6212...