Sinope Sedna VA4220WF Installation Manual

Smart water valve

Advertisement

VA4220WF
VA4221WF
Installation Guide
Smart Water Valve
STEP 1
CONNECTING THE VALVE TO YOUR WI-FI NETWORK
1
Download the free Neviweb app on your
device from the AppStore or Google Play*.
*It is also possible to operate the valve without an Internet connection.
However, you will not be notified when a water leak is detected.
Refer to the "Support" section of our Website at www.sinopetech.com.
4
Open the app and log into your
Neviweb account or create an
account.
Follow the steps to add a
device.
STEP 2
CONNECTING THE WATER LEAK DETECTORS TO THE SMART WATER VALVE
1
The mode switch of the
valve must be in
position "1".
The valve must be
plugged into a
power outlet.
4
Press the detector's connection button.
Light
Green light blinks
Green light lit for 10 s
Red light turns on
*Refer to the "Support" section of our Website at www.sinopetech.com.
*

WARNINGS

The installation of this valve should be performed by a certified
professional in conformity with local and national construction codes.
The valve closes with sufficient force to cut a finger. ALWAYS keep
your fingers away from the ball valve.
Although each unit is pre-tested at the factory, it is strongly
recommended that you test the valve before installation to
ensure proper operation in your home.
Wi-Fi
2
Remove the valve
cover by unscrewing
the 4 screws with a flat
screwdriver.
5
1
Connect your Sinopé
smart water leak
detectors (Step 2).
2
3
2
Press the "B" button to
open the network
connectivity session for
the detectors.
The indicator lights will
light up in sequence to
indicate that the session
is active.
Status
Device is connecting
Successful connection
Connection has failed*
5
Once all the detectors
are connected, press
the "B" button on the
valve to close the
connectivity session.

AVAILABLE ACCESSORIES

Flow Sensor
FS4220
Smart Outlet
SP2610ZB
Load Controller
RM3250ZB
3
Connect the valve to an
electrical outlet, using
the supplied adapter,
near where it will be
installed. By doing so,
you will validate the
range of the Wi-Fi
communication
between the valve
and your network.
3
Connect the detector
to the network from its
installation location.
This will ensure it is
within range of the RF
signal of the valve.
Remove the cover and
insert the batteries.
The connection can be verified at
any time by pressing the water leak
detector's button. The indicator light
will light up in green for 10 seconds
if the unit is connected.
On-Off switch
SW2500ZB
Smart Plug
SP2600ZB
Multicontroller
MC3100ZB

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sedna VA4220WF and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Sinope Sedna VA4220WF

  • Page 1 WARNINGS AVAILABLE ACCESSORIES The installation of this valve should be performed by a certified professional in conformity with local and national construction codes. VA4220WF The valve closes with sufficient force to cut a finger. ALWAYS keep your fingers away from the ball valve. VA4221WF Flow Sensor On-Off switch...
  • Page 2 STEP 3 INSTALLATION OF THE SMART WATER LEAK DETECTORS Place detectors (WL4200) where potential water leakage may occur: Connect the sensor Attach the detector to a to the detector. clean surface where there is • Water heater no risk of immersion. Use •...

This manual is also suitable for:

Sedna va4221wf

Table of Contents