Table of Contents
Advertisement
Periodic maintenance and adjustment
1. V-belt position adjusting bolt
2. Spacer
V-belt position
More than 1.5 mm
(0.06 in) above the
edge
From 1.5 mm (0.06 in)
above the edge to 0.5
mm (0.02 in) below
the edge
More than 0.5 mm
(0.02 in) below the
edge
9.
Tighten the V-belt position adjusting
bolts.
V-belt position adjusting bolt tightening
torque:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
10. Install the V-belt over the primary sheave
assembly.
66
Adjustment
Remove a spacer.
Not necessary (it is
correct).
Add a spacer.
11. Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
1. Secondary sliding sheave
2. Secondary fixed sheave
12. Install the V-belt between the secondary
sliding and fixed sheaves.
1. V-belt
13. Place the left lower cover in the original
position, and then install the screws and
the bolts.
1
1. Left lower cover
Advertisement
Table of Contents
