Advertisement
Hydrocar
What do you need?
Use the scissors to cut two lengths of 4cm(1.5 in.) of rubber
tubing from the long rubber tubing provided in the kit.
Place the red pin into one of the 4cm tubes, and the black pin
into the other 4cm tube. Cut the remaining long tube into two
equal pieces.
Please push and slide the cover and open the battery box.
Try NOT to touch the cables when you open the cover.
Place two AA batteries as indicated.
Push and slide
open the cover
Make sure the switch on the battery box is in the "off" position
before you place the batteries into the box.
WARNING: If the cable is short circuited the batteries inside
could become hot and potentially cause burns, melting of
parts, or create risk of fire.
Note: Battery's energy may be consumed after 4-5 times of use.
Insert the fuel cell into the rectangular slot located on the car chassis.
Place the Hydrogen outer storage cylinder into the round slot located on
the right side of the chassis.
Place the Oxygen outer storage cylinder into the round slot located on
the left side of the chassis.
Hydrocar
AA batteries=2 Units
ASSEMBLY GUIDE
Water=100ml
Connect the short tubes completely onto the short
H
/O
intake nozzles located on the lower sections of
2
2
both "H
" and
"O
" sides of the fuel cell.
2
2
H2 side
Fuel Cell
Remove the cap from each tube connected
to the fuel cell. Using the syringe, inject
distilled water into the Oxygen side of the
fuel cell until the fuel cell is HALF filled with
water.
WARNING: The polymer membrane is an
important part of the proton exchange
membrane (PEM) fuel cell, it should be
prevented from drying out.
O
side
2
bend the
tube this way
O
side
2
Scissors
O2
side
After
water injection
Advertisement
