Mytee Dry GT User Manual

Congratulations on the purchase of your new Mytee Dry GT Upholstery Tool! With proper care and maintenance, we believe this
tool will be a valuable part of your cleaning arsenal for years to come.
Please note that neglect, abuse, or improper use of this tool will void the warranty. Before using this tool, please read and
understand this manual thoroughly.
1 - Package Contents
Mytee Dry GT with
15' x 1.25" hose
combo
One black
and one blue
comfort grip
2 - Setup
Choose between the included
blue and black comfort grips.
Clean the indentation area
on the tool thoroughly with
alcohol. Peel off the adhesive
backing and stick the grip onto
the tool within the indentation.
The vacuum hose can be connected directly to an extractor.
If a longer hose length is necessary, connect to another hose
using the included barb-to-barb fitting. Connect the male
quick connect fitting from the solution line to the female
solution quick connect fitting either on the extractor or a
longer solution hose.
Brass fittings can be extremely hot during and
after use. Tightly wrap the included Heatguard
Hose Wrap around exposed fittings to
prevent burns.
3 - Using the Mytee Dry GT in the
Field
1. After the Mytee Dry GT is connected to your extractor, turn
on the extractor's vacuum(s) and then the solution pump (if
they're on separate switches).
User Manual
2. Make sure the ball valve
Heatguard™ Hose
Wrap
1.5" vinyl slip cuff
3. Dial in the desired amount
1.5" barb-to-barb
coupler fitting
4. Use the vacuum release
5. Begin cleaning by moving the cleaning head of the tool
4 - Maintenance
Maintenance Action
Rinse out any left over
chemicals or dirt residue by
running clean water through
the tool.
Check spray bar for any
clogged orifices. If there's a
clog, clear the obstruction
with a small needle.
1
Mytee, LLC
13655 Stowe Dr.
Poway, CA 92064
858.679.1191
at the end of the solution
hose is turned parallel to
the hose, allowing solution
to flow through.
of solution flow using the
flow control knob. The
amount of solution flow
needed will depend on the
material, its absorbency,
and how soiled it is. Turn
the knob counterclock-
wise to restrict flow and
clockwise for higher flow.
dial to relieve some
suction if necessary. In
general, you'll want to
relieve more vacuum the
more delicate the material
is. Just twist the dial to
reveal the vacuum release holes.
back and forth on the upholstery material.
Frequency
After each use.
After each use.
ADM-8400GT | REV. 12/07/2021