Advertisement
OPERATION OF THE MACHINE
1 . Check air and electrical connection
2. Make sure that the mold is properly connected.
3. Adjust the back gauge to the ideal dimension in your pattern.
4. Set the temperature setting to the appropriate set point by the method described in the relevant
section.
Appropriate heat may vary depending on weather conditions, material density and pattern pattern.
Average Heat Value: 160 C Celsius Degree.
5. Take the machine to automatic mode.
6. Set the pressing time.. The press time is 5 seconds on average. The time may vary depending
on the set temperature and the model.
7. Align the styrofoam as keeping up the the surface that will be pressed.
8. Then press the S1 and S2 buttons simultaneously to start the machine.
The mold goes down and presses during the set time and the press mold will be automatically pulled
up at the end of the period.
In general, the styrofoam may adhere to the surface in the first few usages.
When the press continues, the adhesion condition will disappear automatically.
In addition, silicone based mold release agents can be used to prevent styrofoam stick to the
surface.
Mold release sprays ;
Best mould release KA-2000
Burtech BRT-250
LOCTITE LB 8021
Advertisement
