Advertisement
Quick Links
Advertisement
Summary of Contents for Gemo DT 104 A Series
- Page 1 FOAM HOT STAMP PRESS MACHINE USER MANUAL ABSOLUTELY READ BEFORE USING THE MACHINE...
-
Page 2: Safety Instructions
SAFETY INSTRUCTIONS Before using the machine, read Operator should the following precautions and recommendations Read and understand the operation manual and all safety labels before operating this machine. 2. This product should only be used for the purpose and manner for which it was designed. Protect the press machine from liquid contact to reduce the risk of electric shock. - Page 3 CONTENT SCHEME 1. Pressure indicator 2. Pressure Regulator 3. Emergency stop button 4. S1 ( Start 1) Button 5. 1st Zone Heat Control Device 6. 2nd Zone Heat Control Device 7. 3rd Zone Heat Control Device 8. Press Time Timer 9.
-
Page 4: Switch On And Switch Off
SWITCH ON and SWITCH OFF Main switch , as seen above, switches on/off the main energy of the machine. 1 380 Volt 3 Phases 20 Amper 4*6 mm NYA - NYAF 2 4 - 8 Bar Air Inlet 8 Air Hose... -
Page 5: Operation Of The Machine
OPERATION OF THE MACHINE 1 . Check air and electrical connection 2. Make sure that the mold is properly connected. 3. Adjust the back gauge to the ideal dimension in your pattern. 4. Set the temperature setting to the appropriate set point by the method described in the relevant section. - Page 6 ADJUSTING THE HEAT Three independent Gemo DT 104 A Series PID controlled heat control devices have been used in Masterpress Jambs Pattern Machine. Hold the SET button for 3 seconds to adjust the temperature.At the end of the time, the red PV value in the top row starts to flash.Set the desired value by the up and down key.Then press the SET...
- Page 7 Physical Dimensions and Features Machine Weight : 650 KG ( No Mold) Mold Dimensions...
- Page 8 Electrical Diagram and Features...
- Page 11 ATTENTION It is Dangerous to Intervene other than Authorized Persons ATTENTION Electrical Voltage causes sudden deaths and serious injuries. Pac Makina Otomasyon Ltd. Şti. 3. Cadde No:1/N Estim Kısıköy Menderes İZMİR +90 232 257 64 66 www.pac-cnc.com pacmakina@gmail.com...