Eastwood 33968 Instructions Manual page 8

SET-UP
Ultrasonic Cleaning occurs when high-frequency,
ultra-sonic vibrations are created by Transducers
and transmitted through the liquid cleaning media.
As a result, microscopic bubbles are created on
a molecular level. These bubbles very effectively
penetrate into and behind dirt and grime particles
and explode violently causing the dirt to dislodge
leaving behind a clean, like new surface.
FIRE OR EXPLOSION HAZARD!
DO NOT use solvent based or flam-
mable cleaning agents in this Ultra-
sonic Cleaner. The unit is designed to
operate with water-based cleaning
agents only. Exposure to solvents
will destroy some components and
could present a fire hazard.
• Place parts to be cleaned into the supplied
Basket. Keep a separation between parts,
not allowing them to touch as this will
greatly reduce the cleaning action.
• Lower the Basket into the Tank area
(FIG 3).
The Basket MUST be used. DO NOT allow the parts to be cleaned to come in contact
with the inside walls or floor of the Cleaner.
• Fill the Tank with an approved water-based cleaning solution ONLY to the maximum fill level
indicated on the inside wall of the Tank (FIG 4). DO NOT exceed the maximum fill level line
which is the interior wall ledge that supports the Basket.
8
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
FIG. 3 FIG. 3
FIG. 4 FIG. 4
Fill
Line