Table of Contents
Advertisement
A
A ccessories
The following accessories are supplied with the air conditioner.
Accessories in the Outdoor Unit Case
3-wire
Power Cable
Assembly Cable
(option)
Tube-connector
Tube-connector
(Pipe 12.70mm;
(Pipe 12.70mm;
Bolt 9.52mm)
Bolt 15.88mm)
The 3-wire power cable and the 4-wire assembly cable are optional. If these cables are not supplied,
use the standard cable approved by IEC standard.
Please, check "Connecting the Cables to the Outdoor Unit" section.
Cutting/extending the piping
1. Make sure that you have the required tools available (pipe cutter, reamer,flaring tool and pipe holder).
2. If you wish to shorten the piping, cut it using a pipe cutter, taking care toensure that the cut edge remains at a 90° angle with the side of
the pipe,and referring to the illustrations below for examples of edges cut correctlyand incorrectly.
3. To prevent any gas from leaking out, remove all burrs at the cut end of thepipe, using a reamer.
Face the pipe down while removing the burrs to make sure that burrs do not get in to the pipe.
10
4-wire
Installation
Manual
(option)
Oblique
Flare Nuts, 15.88mm
Rubber Leg
outer pipe diameter
Rough
Burr
Flare Nuts, 9.52mm
outer pipe diameter
Advertisement
Table of Contents
