Overhead door G Series Quick Start Manual

Transmitter Switch Settings
1 2 3 4 5 6 7 8 9 10 11 12
up up up
up up down
up down up
up down down
down up up
down up down
down down up
down down down
Resulting Security Code
___ ___ ___ ___
PLEASE NOTE:
DURING 2000, THE
FACTORY MODIFIED
THIS KEYPAD.
IF THE KEYPAD DOES
NOT WORK AFTER
FOLLOWING THESE
DIRECTIONS - TRY
REPEATING THE
DIRECTIONS
BUT SKIP STEP #2
Overhead Door Company
of Cedar Rapids & Iowa City
Always disconnect operator from door before programming
to avoid injury to yourself or the operator
OVERHEAD DOOR • "G" Series Non-CodeDodger OR GENIE
Battery: Access Panel is at the bottom edge of the keypad.
To Operate: Depress area and slide down. Light should come on
when cover is raised.
Reset Keypad:
7
6
1. Open cover on keypad just enough to press "#" & "8" at the
5
same time. While pressing these keys, raise the cover all the
4
way (this erases the old code). Release the buttons.
3
Close the cover. Open cover fully.
2.
2
3. Press numbers "3", "5", "7", and "#". The red light should be
1
blinking about once a second.
0
4. Enter your new PIN number and press #. The red light should
be blinking faster.
5. Enter the security code number and press "*"- red Light will
turn off.
6. Close keypad cover fully.
7. Slide keypad cover open fully and enter the pin number and
press "*" to test with your new code number.
To Change Pin # Without Resetting Keypad:
1. Open cover fully.
2. Enter OLD pin number and press "#" - red light will blink
slowly.
800-393-9976
• Wireless (slide up cover)