Arrow ROT4500K-A Manual page 15

BALANCING ACCESSORIES
To true up or balance an accessory, slightly loosen collet nut
and give the accessory or collet a 1/4 turn. Re tighten collet
nut and run the Rotary Tool. To maintain balance on abrasive
wheel points, before each use, with the wheel point secured
in the collet, turn on the Rotary Tool and run the Dressing
Stone lightly against the revolving wheel point. This removes
high spots and trues up the wheel point for good balance.
Uses Accessory Included with Kit
Cutting Abrasive Cutting Discs
5pcs 1.25" (32mm) fiberglass reinforced
cut-off wheels
Sanding 1pc ½" (12.7mm) sanding drum
8pcs ½" (12.7mm) sanding band
Sanding 30pcs 20mm sanding papers
Polishing 2pcs 1" (25mm) polishing wool wheels
Grinding 2pcs aluminum oxide grinding stones
1pcs silicon carbide grinding stone
ACCESSORIES
USING ACCESSORIES
There are a variety of attachments supplied with this tool.
Some of these come ready to use and can be fitted to the
tool without any further assembly. However, others require
fitting to a mandrel before they can be used. Here is a list of
accessories.
Accessory Mandrel used with Accessory
15