Cleaning The Ceiling Cover; Cleaning The Air Filter; Installation Instructions For Stacking - Samsung MJ26A6093 Owner's Instructions & Cooking Manual

CLEANING THE CEILING COVER

1. Hold side stoppers of ceiling cover with both hands and pull them in and
down. Then take the ceiling cover out of the oven cavity.
2. Rinse ceiling cover in soapy water or Food Sanitizer Solution.
3. Be sure to replace the ceiling cover before using the oven.
CAUTION : Ceiling cover must
be in place securely when
you use the oven. When you
removed the Ceiling Cover for
the purpose of cleaning, be sure
to be extremely careful about the
exposed inside components on
the top of the oven cavity. If any
of them are deformed, abnormal
symptom can happen such as arcing or sparks during operation. In case
of such problem, contact the nearest after-sales service centre.

CLEANING THE AIR FILTER

Clean the Air Filter regularly according to the following instructions.
The oven may have problems when the Air Filter becomes clogged with
dust.
1. Remove the bolt at both ends of
the Air Filter.
2. Lift the Air Filter off the post
carefully.
3. Wash this filter in warm soapy
water.
4. Be sure to replace the Air Filter
before using the oven.
If the Air Filter becomes clogged with debris, this will cause an overheating
problem on the oven.
If the want to change the air filter clean time, refer to "Programming Air
Filter Clean Time" in page 15.

INSTALLATION INSTRUCTIONS FOR STACKING

Important
1. Disconnect the power cord from the wall socket before attempting
installation.
2. For stacking installation, you must use the "bracket plate" which is
enclosed with this unit.
3. The maximum stacking height is two units.
Stacking the two units is limited to the following models.
CAUTION :
Ceiling Cover
Installation
1. Stack two units together.
2. Remove 6 screws as shown in the figure.
3. Place the Bracket-plate to join the two units.
4. Attach and tighten 6 screws as shown in the figure here.
5. Ensure the top oven is at a safe and workable height.
Lorem ipsum
Bolt
17
Be sure the oven cavity is empty.
Screw
Bracket-Plate