Care And Cleaning - Kohler Forte K-10282 Installation And Care Manual

Inlet
Showerhead
1. Install the Showerhead
CAUTION: Risk of product damage. To avoid plugging the
showerhead spray outlets, use thread sealant tape on the shower
arm threads.
Remove the existing showerhead and thread sealant tape from the
shower arm, if applicable.
Apply thread sealant tape to the threads on the shower arm.
Run cold and hot water through the shower arm for several
minutes to flush out dirt and debris.
Place the screen/washer with the tapered side down into the
showerhead inlet.
Secure the showerhead to the shower arm using a clean strap
wrench. Do not overtighten.
Pivot the showerhead to verify smooth operation.
Run water through the showerhead to check for leaks between
the shower arm and showerhead inlet. Adjust as needed.

Care and Cleaning

For best results, keep the following in mind when caring for your
Kohler product:
• Test First - Always test your cleaning solution on an
inconspicuous area before applying it to the entire surface.
• Do Not Let Cleaners Soak - Do not allow cleaners to sit or soak
on the product.
Kohler Co.
Apply thread sealant tape.
Screen/Washer
3 1054642-2-B