Barker 25895 Owner's Instructions

TOTE-ALONG OWNER'S INSTRUCTIONS
25 Gallon Tote
out of box.
correct way--with the loop facing out or away from tank, so the handle will lean against tank when it is attached). Attach square black
plastic cap to tow handle.
Attach tow handle
with pin.
Step 4 - Put sewer hose onto adaptors and tighten with clamps. (This is the hardest thing hardest part of putting your tank together.)
To make your life easier and less muttering under your breath, take a hair dryer, heat the hose slightly. The hose will expand to make
the connection simpler. You can do it without a hairdryer, but you may break a nail and it takes some time and patience.
get one adaptor end on, put the two silver hose clamps onto hose and then attach the other adaptor. That way you won't have to
unscrew the hose clamp to insert it around the hose. Now, tighten the hose clamp at the base of the adaptor and hose. (You can use
a coin to tighten, if you don't have a screwdriver handy.)
Step 5 - Attach one end of the rubber strap to 3" cap(s) and attach the other end of rubber strap to tank (one on side at valve and one
on top). Close caps on tank for transporting. When you take the caps off to attach 3" adaptor/sewer hose assembly for emptying,
you will still have your transport caps at hands reach.
3" cap with
strap attached--
side valve
25 GALLON - P/N 25895
Contents of hardware bag ** and tow handle.
Tow handle
with pin
attached.
Tow handle attached
to tank
3" cap with
strap attached--
top of tank
**Contents: Instructions, warranty
card, tow handle, pin for handle, black
square cap for handle, 1 grey filler
hose, 1 bobber gauge, 2 bayonet
hose adaptors, 2 hose clamps, 1
garden hose cap, 1 gasket for garden
hose cap, 2 - 3" caps, 2 straps for
caps, and 1 sewer hose.
Step 1 - Take everything out of
the box (tank and hardware bag
and handle).
Step 2 - Take everything out of
the plastic bag.
Step 3 - Attach tow handle (be
sure the handle is turned the
Attach black cap.
Once you
Completed
sewer hose
assembly
OVER PLEASE