StonePoint 1G1200S-PW Instructions

Please read all instructions thoroughly and carefully prior to installing this product. Retain these instructions for future
reference.
Failure to follow these instructions could result in voiding the product warranty. Keystone Group assumes no liability or
responsibility for claims arising from improper installation or improper use.
For questions in regard to the warranty of this product, contact us at 303.652.6164 or email us at info@keystonegroupusa.com
READ FIRST: IMPORTANT SAFETY INSTRUCTIONS
Before you begin installing, servicing, or maintenance of this product, follow these general precautions.
•
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions
and other hazards please read all warnings and instructions included with and on this product prior to installation.
•
For commercial installation: service and maintenance of this product should be performed by a qualified, licensed
electrician.
•
For residential installation: If you are unsure about the installation or maintenance of this product, consult a
qualified licensed electrician.
o
Do not mount the unit against flammable surfaces.
•
This product CANNOT be used with a dimmer switch, motion or occupancy sensor or other electronic switching
devices unless otherwise designated. LED products must be powered directly to a switched circuit.
•
This product should not be used in areas with limited ventilation or high ambient temperatures.
•
This product is intended to be connected to a properly installed and grounded UL listed junction box.
WARNING: RISK OF ELECTRICAL SHOCK
•
Turn off electrical power at fuse or circuit breaker box before wiring product to the power supply.
•
Verify the supply voltage is correct before installing (110-240V).
•
Make all electrical and grounded connections in accordance with the National Electric Code and any applicable local
code requirements.
•
All wiring connections should be capped with UL listed wire connectors.
CAUTION: RISK OF PRODUCT DAMAGE
•
Never connect components with power on.
•
Do not mount or support product in a manner that can cut the outer jacket or damage the wire insulation.
•
Avoid covering LED products with insulation, foam or other materials that will prevent convection or conduction
cooling.
•
Never connect an LED product directly to dimmer packs, occupancy sensors, timing devices, or other related control
devices, unless individual product specifications deem otherwise.
•
Unless individual product deems otherwise; do not exceed product's maximum temperatures.
•
LED products are Polarity Sensitive, ensure proper polarity before installation.
Switch Control Security Light
Model: 1G1200S-PW/1G1200S-PB