Table of Contents
Advertisement
Fit the upper flue duct section.
2.
Gently push the two side panels apart, and then
‒
hook them into the angle bracket on the left and
right.
Screw the upper flue duct section onto the sides
‒
of both angle brackets.
If air extraction is required, fit the flue duct section
with its slots facing downwards.
Install the lower flue duct section.
3.
Gently push the two side panels apart, hook
‒
them in behind the upper flue duct section and
then push them back together as far as they will
go.
Place the flue duct sections onto the appliance
‒
and screw them to the sides of the angle
bracket.
To prevent scratches, lay paper over the edges of
the lower flue duct section to protect the surface.
Removing the appliance
Remove the flue duct.
1.
Disconnect the appliance from the power supply.
2.
Loosen the exhaust pipe.
3.
Take hold of the filter cover with two hands and
4.
open it.
Remove the grease filters.
5.
To avoid causing damage, do not bend the grease
filters.
Loosen the screws for the appliance bracket slightly
6.
but do not undo them fully.
Remove the appliance.
7.
Loosen the angle bracket for the flue duct.
8.
Installation instructions en
15
Advertisement
Table of Contents
