Advertisement
Device Installation/ 设备安装
C. Beam-mounted Installation/ 横臂安装
Unfasten the three hose clamps and thread them through the installation holes on the pole-mount bracket.
2
Place the hose clamps around the beam and tighten them to affix the pole-mount bracket firmly onto the
beam.
将 3
个喉箍环穿过抱装支架的安装孔，并环绕在横臂上，拧紧喉箍。使用喉箍将抱装支架安装到横臂上。
D. Pole-mounted Installation/ 抱柱安装
Install the wall-mount bracket into No. 5 holes on the pole-mount bracket (for the No.5 hole identifier, see
1
the silk screen on the physical device).
将壁装支架安装到抱装支架 5 号孔位（5 号孔位标识请参见实物上的丝印）上。
Adjust the surveillance angle. Fasten all screws on the universal joint and use captive screws to fasten the two
3
planes of the universal joint to fix the universal joint. Then, adjust the position of the sunshield.
调整好监控角度，拧紧万向节上的所有螺钉，再使用辅助紧固螺钉在万向节的两个面上拧紧，使万向节固定。同时调整好
d
遮阳板位置。
c
a
Fix the camera to the universal joint with the screws in No. 1 holes. Loosen screws a and b on the universal
2
joint for the universal joint to rotate freely. Adjust the horizontal and vertical shooting angles and tighten all
screws on the universal joint.
通过标识 1 位置的螺钉将摄像机固定到万向节上，拧松万向节上的 a 和 b 螺钉，使得万向节可以自由转动。初步调整好
水平和垂直监控角度，拧紧万向节上的所有螺钉。
4
d: Move it back and
forth. Then, you can
adjust the position of
the sun shield.
d ： 通 过 前 后 移 动 此 位
b
置，可调节遮阳板。
1
NOTE/ 说明
b
a
Advertisement
