Table of Contents
Advertisement
Check that all hardware is properly installed.
Always tighten to torque chart specifications unless
instructed otherwise in this manual.
Make sure the Tarter attachment is properly secured,
adjusted and in good operating condition.
A minimum of 20% of tractor weight must be on the
tractor's front wheels when Tarter attachments are
in use. Without this weight, the tractor could tip over,
causing personal injury or death. The weight may be
attained with a loader, front wheel weights, ballast in
tires or front tractor weights. Weigh the tractor and
Tarter implement. DO NOT ESTIMATE.
STARTING AND STOPPING
Understand how to stop the Power Unit and Tarter
attachment quickly in case of an emergency.
Before starting, check over all pins, bolts, and
connections to be sure all are securely in place. Make
sure power unit is in neutral
Start the power unit from the driver's seat.
Always lower Tarter attachment to the ground and
relieve hydraulic pressure. Park on level ground, shut
off the power unit, put the power unit or park or set the
parking brake, and remove the key when leaving the
equipment.
TRANSPORTATION
Never transport the power unit or the Tarter
attachment while under the influence of alcohol or
drugs.
Always comply with all federal, state and local laws
regarding lighting, marking requirements and
transportation of farm equipment on a public roadway.
Never allow riders on the power unit or Tarter
attachment.
Maximum transport speed for an attached equipment
is 20 mph. DO NOT EXCEED. Never travel at a speed
which does not allow adequate control of steering and
stopping.
Transport only in daylight or satisfactory artificial light.
Always transport loads low to the ground to maintain
stability of the power unit.
Be aware of overhead utility lines.
Avoid contact with any overhead utility lines or
electrically charged conductors.
Watch for hidden hazards on the terrain during
transport.
Do not operate or transport on steep slopes.
Do not stop, start, or change directions suddenly on
slopes.
Use extreme care and reduce ground speed on
slopes and rough terrain. When encountering rough
terrain during transport, reduce the power unit speed
to minimize the horizontal movement of the Tarter
attachment.
Ensure the towing vehicle and trailer are safely
capable of transporting the Tarter attachment and that
everything is properly secured.
OPERATION
Be sure the power unit is properly counterbalanced
with weights before attempting to lift any load.
Never operate the power unit or the Tarter attachment
while under the influence of alcohol or drugs.
Make sure the Tarter attachment is securely mounted
to the loader. Failure to install lock pins or have the
locking mechanism engaged, could result in injury or
death.
Always know the weight of the load being lifted.
Maximum lift capacity should never exceed rated lift
capacity of the Tarter attachment. It should never
exceed 80% of the power unit rated lift capacity for an
attached front loader. Use the smaller of the two lift
capacities to determine maximum lift capacity.
Lightweight power units may need weight added to
the rear to maintain control and prevent forward or
side tipping caused by a heavy front load. Consult your
power unit Operator's Manual to determine proper
weight requirements and maximum weight limitations.
Operate only in daylight or satisfactory artificial light.
Do not allow bystanders in the area when operating,
attaching, removing, assembling, or servicing the
power unit or Tarter attachment. Never allow anyone to
SA F E TY
9
Advertisement
Table of Contents
