Advertisement
MULTI-PURPOSE CHOPPER OPERATION
1.
Before first use, the chopper accessories must be cleaned. Wash with warm
water and mild detergent. Rinse with fresh water and allow to dry.
Your multi-purpose chopper is now ready for use.
2.
Ensure unit is unplugged from wall power outlet.
3.
Assemble the main blade unit with the side blade unit by sliding the side blade
unit over the main blade unit shaft. Twist side blade to lock into place. **Note:
exercise caution when mating the blades together as they are very sharp**
4.
Insert the assembled blade into the chopper bowl and onto the spindle.
5.
Add ingredients into the bowl being careful not to touch the blades.
6.
Place lid onto the bowl and insert the chopper body into the lid.
7.
Ensuring
your fingers are not pressing either of the buttons on the top of the
chopper body, plug the power cord into the A/C outlet and switch on.
8.
Begin operation by pressing the power level buttons on the top of the chopper
body.
9.
After use, unplug from the wall power outlet.
WARNING The multi-purpose chopper blades are very sharp, avoid touching
them and handle with care.
WARNING Do not plug the appliance into power before it is fully assembled.
WARNING Exercise caution when removing the attachments from the chopper
and ensure the appliance is turned off and unplugged whilst fitting attachments.
WARNING Do not blend hot or boiling foods or liquids as there is a risk of burns
or scalding.
CAUTION It is not recommended to run the multi-purpose chopper
continuously for more than 2 minutes at a time for light substances. Do not mix dry,
thick or heavy mixtures continuously for more than 30 seconds. Stop the operation
and stir the ingredients before continuing. Allow the motor to rest for 1 minute
bet
ween each use.
NOTE: All multi-purpose choppers are designed to operate only when the power
buttons remain depressed.
© 2021 RVM Australia Pty Ltd. All Rights Reserved
5
Advertisement
