Connections
Speaker Components
(L) (R)
FRONT/FRONT TOP
SCREW (4x20): 8EA
SCREW (5x15): 4EA
Installing the Speakers on the Tallboy Stand
1.
Turn the Stand Base upside-down and connect it to
the Stand.
2.
Insert small screws (4x20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
!
CAUTION
When you use a torque screwdriver, be careful not
to put excessive force. Otherwise, it runs idle or
can be damaged. (torque screwdriver- below 15
kg.f.cm)
3.
Insert the large screw (5x15, For connecting Stand
& Stand Base) clockwise into the hole on the rear of
the stand using a screwdriver.
4.
Connect the upper Speaker to the assembled
Stand.
5.
Insert another large screw (5x15, For connecting
Speaker & Stand) clockwise into the hole on the rear
of the speaker using a screwdriver.
6.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
20
English
HT-D6730W_XAA_1226.indd 20
HT-D6730W_XAA_1226.indd 20
STAND
SUBWOOFER
CENTER
(L)
(R)
SURROUND
SWA-5000
Wireless Receiver Module
STAND BASE
SPEAKER CABLE
1
Stand Base
Stand
3
5
TX Card
Speaker Cable (2EA)
2
4
Speaker
Stand
6
2011-12-26
2011-12-26
5:45:39
5:45:39