Table of Contents
Advertisement
REPLACEMENT OF LOCK RELEASE LEVER
Removal
1.
Place the slider in the cassette down position.
(Turn the coupling on the worm shaft clockwise
until the slider is in the cassette down position.)
Note: Before shifting, unlock the slider.
2.
Slightly widen the cassette housing frames (R)
and (L) to unhook the slider holders (R) and (L) of
the slider assembly off the grooves of the
cassette housing frames.
Cassette housing
f r a m e (RI
Slider holder (RI
3. Lift the slider holder (R) upward about 2mm off
the slider by pressing two catches with a thin tip
screw driver. Take care not to damage the
catches.
Cassette houslng
Slider holder (Li
Figure 1-17.
about 2 mm.
Lock release lever
Lock release lever spring
Figure l-18.
4.
Remove the lock release lever
holder(R)
l
Reassembly
Follow the steps for removal In tne reverse order.
1 .
(See Figures 1-17 and l-18.)
2.
Attach the lock release lever to the slider holder
3.
Slide the slider holder (RI downward so that the
two catches of the slider holder (R) fit the
opening of the slider.
4.
Slightly widen the cassette housing frames, and
set the pins of slider holders (R) and (L) into the
grooves of the cassette housing frames.
Note: Check if the pins of the slider holders (R)
and (L) fit the grooves of the cassette
housing frames, and if the drive gear arm
is sufficiently engaged with the slider
holders.
5.
Turn the coupling counterclockwise until the
slider is at the cassette insertion opening.
TO RUN A TAPE WITHOUT THE CASSETTE
HOUSING CONTROLASSEMBLY
1. Plug in the power cord.
2. Turn on the power switch.
3. Open the lid 0 of a cassette tape by hand.
4. Hold the lid with a pair of vinyl tapes 8.
5. Set the cassette tape in the mechanism chassis.
6. Weight the cassette tape with a weight @ to
prevent float.
7. Perform running test.
Cassette tape
float 1500 gi
Note:
The weight should not be more than 500 g.
15
from the slider
. . .y
,
Figure l-19.
here
Advertisement
Table of Contents
