LG BG630 Owner's Manual page 6

4 SAFETY PRECAUTIONS
CAUTION
When installing the projector on a
y y
table, be careful not to place it near
the edge.
- The projector may fall, causing injury
to persons or damage to the projec-
tor. Make sure that you use a cabinet
or stand that fits the projector.
Turn off the projector, disconnect the
y y
power supply, and remove all connec-
tions before moving the projector.
- A damaged cord may cause a fire or
an electric shock.
Do not place the product on an un-
y y
stable or vibrating surface such as a
wobbly shelf or a slope.
- It may fall or flip and cause injury.
Be careful not to tip or drop the prod-
y y
uct over when connecting external
devices to the product.
- This may cause injury to persons or
damage to the product.
Power
WARNING
The grounding wire should be con-
y y
nected.
- Be sure to connect the grounding
wire to avoid damage to the product
or an electric shock when there is a
short circuit.
If it is not possible to ground the unit,
purchase a circuit breaker and con-
nect the product to its wall outlet.
Do not try to ground the product to
the gas pipe, water pipe, lightning
rod, or telephone line, etc.
The power plug should be inserted
y y
fully into the power outlet.
- An unstable connection may cause
fire.
Do not place heavy objects on the
y y
power cord.
- This may cause fire or electric
shock.
Never touch the power plug with a
y y
wet hand.
- This may cause an electric shock.
Do not plug too many devices into
y y
one multi-power outlet.
- This may cause fire due to the
power outlet overheating.
Remove dust or contaminants around
y y
power plug pins or wall outlets.
- Failure to do so may cause fire.
To turn off the main power, remove
y y
the power plug, which should be
positioned so it is easy to access for
operation.
To prevent damage to lamp, unit must
y y
remain plugged in for approximately 3
minutes after power down to allow for
proper cooldown.