Advertisement
TABLE OF CONTENTS
Kit Contents .....................................
Table of Contents, Safety Information, and Tips ........
Introduction ................................................................
ASSEMBLY STARTS ON PAGE 3
Candy Claw Machine Assembly ..........................
How to Use the Candy Claw Machine ................
Experiments ....................................................
How Hydraulics Work ......................................
Handy-Dandy End Effectors ............................
About Gears and Levers .............
WARNING
Not suitable for
children under 3 years.
Choking hazard —
small parts may be
swallowed or inhaled.
Strangulation hazard
— long tubes and belts
may become wrapped
around the neck.
Keep the packaging
and instructions as
they contain important
information.
Refer to the packaging
for the nutritional
information and the
ingredients list for the
lollipops.
You will also need:
Scissors, diagonal
cutter, nail file, basin
of water, oil (baby oil
or cooking oil)
550103-02-200821
Inside front cover
Inside back cover
!
Dear parents and adults,
Children as young as six years of age
can enjoy experimenting with the
built Candy Claw Machine, but most
children under eight will need a lot of
help building it. Regardless of their
age, please support your child with
advice and a helping hand, especially
during tricky assembly steps. Before
beginning, read the instructions
together and discuss the safety
instructions.
To prevent damage to the work
surface on which your child is
building, provide them with a mat or
other surface protection.
– You must carefully cut the plastic parts out of their frames
with diagonal cutting pliers (diagonal cutters) or scissors.
– Remove the parts from the frames only when they are needed.
– Remove excess material (burrs) from the parts before assembling them.
Normal scissors do not cut as precisely as diagonal cutters, so you may have
to file some of the rough edges down with a nail file or sandpaper.
– Assemble everything in the order shown. Don't jump ahead!
– You must lubricate each piston seal (P13) inside the
hydraulic cylinders with oil. See page 5.
Additional information
1
check it out
2
3
13
14
15
16
When cutting the plastic parts out of
the frames with the diagonal cutter
or scissors, special care must be
taken, not just because of the sharp
edges on the tools, but also because
the plastic parts can yield sharp
edges or burrs. These can be
removed with the help of the diagonal
cutter or a nail file. Supervise your
child when they are using the sharp
tools until you trust that they can
handle the tools independently.
lot of fun building and playing with
the Candy Claw Machine!
Burr
Clip
Burr
Burr
Candy Claw Machine
can be found in the
sections on
15, 16, and the
pages
Inside back cover.
We hope you and your child have a
Clip
Clip
1
Advertisement
