Disengaging The Blade-Control Switch (Pto); Operating The Throttle; Operating The Choke; Operating The Key Switch - Toro Titan X4850 Manual

Disengaging the
Blade-Control Switch
(PTO)
Figure 27

Operating the Throttle

You can move the throttle control between the F
and S positions (Figure
LOW
Always use the F position when engaging the PTO.
AST
Figure 28

Operating the Choke

Use the choke to start a cold engine.
1. Pull up the choke knob to engage the choke
before using the key switch
Note:
Ensure that you fully engage the choke.
You may need to hold the knob up when you
use the key switch.
2. Push down the choke to disengage the choke
after the engine has started
g009174
AST
28).
g295539
(Figure 29).
(Figure 29).
1. O position
N

Operating the Key Switch

1. Turn the key to the S
Note:
When the engine starts, release the key.
Important:
Do not engage the starter motor
for more than 5 seconds at a time. If the
engine fails to start, wait 10 seconds between
attempts. Failure to follow these instructions
can burn out the starter motor.
Note:
You may need multiple attempts to start
the engine when you start it the first time after
the fuel system has been without fuel completely.
2. Turn the key to the S
engine.
24
Figure 29
2. O position
FF
position (Figure
TART
Figure 30
position to shut off the
TOP
g295540
30).
g008947