Regulation Of Water Outflow Speed; Installation Testing - SANPLAST FREE AIR Assembly, Installation And Operation Instructions

FREE LINE
3�5�3 Regulation of water outflow speed
The regulation of water outflow from the bathtub is made by regulation of siphon cover height (closing/
opening the hole)
Notice!
GB
Increasing factory set height of siphon cover should be done only with the regulation of M4
screw placed on the bottom of siphon cover. (pic. 2).
"siphon cover"
Pic. 2

3.6 INSTALLATION TESTING

All the bathtubs are carefully checked and tested, in regard to proper functioning and safety (the "B" mark).
However, it is recommended to recheck as far as damages may have occurred while transportation.
Having finished all installation works, (before fixing the frame) it is compulsory to check proper functioning
of all system appliances by: filling with water (1), switching on the mains (2), activating and checking
the massage system according to the instruction manual (3), checking the tightness of pipes and their
connections (4), leaving the system working for 10 minutes (5), and then deactivating it (6), and checking
the outlet tightness by emptying the bathtub (7).
Eventual claims should be reported immediately.
31