Table of Contents
Advertisement
Operating your SX series active studio monitor system
SX series control & connector panel
The SX series monitor speaker's rear panel is where you will make
your connections for both AC power and audio signal. The rear panel
is also contains the volume control to adjust the output level. The
following section details the rear panels controls and connections.
Power the SX series active studio monitor system
Connect the unit to an AC power supply since the SX series monitor
speaker is an active studio monitor with an on-board power
amplifier. Make sure that the main power switch is set to the off
position and connect the supplied IEC power cable into the AC inlet.
Things that go Hum!
When running power cables, be careful not to run the AC power cords
or AC extension cords in parallel to your input cable. This will help
reduce any AC hum that can be picked up. If you have to cross them at
a 90-degree angle for the lease amount of induced hum. Using the SX
series monitor speaker's balanced XLR input connector will greatly
protect against the induced hum thanks to the common rejection (the
induced hum is phase cancelled) that is balanced input circuit provides.
Power switch
1
Turn the unit on/off.
AC inlet
2
Connect the supplied IEC power
cable here.
3
Volume control
The volume control is used to
adjust the overall output level of
the SX series monitor speaker.
When operating the unit for the
first time, start with the volume
control set all the way off. Slowly
raise the volume control to reach
a comfortable listening level.
9
studio
m o n i t o r
3
2
1
220V
Advertisement
Table of Contents
