Advertisement
If the vehicle is not performing well at a specific condition note the AFR Correction and light
indicating load condition: Idle, Cruise or WOT. Increase or decrease the fuel at the indicated load
point with the + or – buttons. Continue driving and allow time for corrections to be made; AFR
Correction value should decrease. Repeated adjustments may be necessary.
NOTE:
• Fuel Modifiers should only be applied if absolutely necessary.
• Many instances involving poor performance that indicate adjustment to these modifiers are
related to underlying issues related to other component failures or improper installation.
Please inspect EFI system, all related components and that Setup Wizard information related
to the installation was properly selected.
• For situations involving very poor performance Edelbrock technical assistance is advised.
• Self-Learn and Clear Self–Learn functions are provided for procedures that may be requested
when being assisted by Edelbrock technical assistance.
Reset Self-Learn
Clears the self-learning table. Any corrections that were previously learned will be deleted.
NOTE: Driving the vehicle through various loads, speeds, and conditions is recommended if
resetting the self-learn.
Reset Modifiers
Restores all default Advanced Tuning modifier values back to the ECU. These values should be
applicable for most engine configurations. The Idle Target and TPS must be re-calibrated after
applying. All Advanced Tuning Settings should be verified.
Save Map/Settings
Saves the current map or settings from the ECU to the Android Device. All files will be saved to
"My Maps" in Edelbrock folder on the device storage.
○
Saving ECU Settings will store the current Advanced Tuning Modifiers and self-learning
progress to the Android device.
Restore Map/Settings/Firmware
Manually reload an Edelbrock File (Map, ECU Settings, Firmware) back to the ECU.
- Do NOT restore/load any files while driving or while the engine is running.
- Always Power-Cycle the ECU (Key-Off 10 seconds, then Key-On) after loading a Map or
Firmware file to apply the new changes.
- When Flashing Firmware, always make sure the Bluetooth connection is stable and
consistent before attempting to load a Firmware file. It is recommended to use the
E-Tuner app while being as close as possible to the ECU or Bluetooth antenna.
ECU SETTINGS MENUS
CAUTION!
9
Advertisement
