CleanForce CF1400 Manual page 2

3. Why can't my unit reach high pressure?
Symptom Cause
Unit does not Diameter of garden hose is too
reach high small.
pressure.
Water supply is restricted.
Not enough inlet water supply.
Water inlet filter is clogged.
Power nozzle is in low-pressure
position.
Pump is sucking air.
4. Why does the pressure vary from high and low?
Symptom Cause
Output pressure Not enough inlet water supply.
varies high and
low.
Pump is sucking air.
Water inlet filter is clogged.
Discharge nozzle is obstructed.
Calcified gun, hose or power
nozzle.
5. Why is there no detergent coming out?
Symptom Cause
No Detergent Detergent container is empty.
Detergent bottle or suction tube not
properly connected.
Detergent is too thick.
Filter on detergent suction tube is
clogged.
Damaged or clogged detergent
suction tube.
Nozzle is in high-pressure position. Turn nozzle tip to low-pressure position.
Discharge nozzle is obstructed.
6. Why does the garden hose connection leak?
Solution
Replace with a 1" (25 mm) or 5/8" (16 mm) garden hose.
Check garden hose for kinks, leaks and blockage.
Open water source fully.
Remove filter and rinse in warm water.
Turn power nozzle to high-pressure position.
Check that hoses and fittings are airtight. Turn "OFF" machine,
and purge pump by squeezing trigger gun until a steady flow of
water emerges through the nozzle.
Solution
Turn water on fully. Check garden hose for kinks, leaks or
blockage.
Check that hoses and fittings are airtight. Turn "OFF" machine,
and purge pump by squeezing trigger gun until a steady flow of
water emerges through the nozzle.
Remove filter and rinse in warm water.
Blow out or remove debris with a fine needle.
Run distilled vinegar through detergent tank.
Solution
Add more detergent.
Check connections.
Dilute detergent.
Run warm water through filter to remove debris.
Remove obstruction or replace detergent suction tube.
Blow out or remove debris with a fine needle.