BELLATERRA HOME S8228-8 Instructions

8" two handle widesperad lavatory faucet with pop-up drain

Advertisement

B
B
ELLATERRA
Thank you for selcting our product for your home.
1
We hope that you are completely satisÿed with your purchase.Please read below instructions carefully before installing new faucet.
8" Two handle widesperad lavatory faucet with pop-up drain
2 3
Model Number: S8228-8
4
5
6
7
8
Care & Maintenance:
11
* To keep the product clean & shining, follow the steps below:
• 1. Rinse with clean water & dry with a soft cloth.
12
• 2. Do not clean with soaps, acid, polish, abrasives, or harsh cleaners.
13
• 3. Do not use cloth with a coarse surface.
• 4. Unscrew the aerator and clean when necessary.
* This installation manual is subject to change without further notice.
* Please read your care and maintenance documentation to determine the limits of proper use.
* This product has been manufactured and tested to the highest quality standards .We o° er our customers thoughtfully
crafted ÿxtures & accessories, engineered for enduring performance over years of use.

Prior to Installation:

• T urn o f f the hot and cold water supply at the angle stops
and turn on the old faucet to release any built up pressure.
Remove existing faucet. Clean sink or countertop to remove
any debris, plumber 's putty , or silicone.
• Place bucket under angle stops. Turn on to ˜ush any debris
prior to installing new plumbing. Shut o° angle stops.
• Pre-drilled hole size requirement: 1-3/8" (min) – 1-1/2" (max)
• Max countertop thickness: 1-3/8"

Tools you will need:

Adjustable Wrench
10
H
LLC
OME,
9
12
Close
25°
Open
S crewdriver
Safety Goggles
Hexagon Nut
11
13
90°
Left
Hot Water
Bucket
1
Hot
Cold
Water
Water
Push
Teflon Tape
Silicone Sealant

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S8228-8 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BELLATERRA HOME S8228-8

  • Page 1 Thank you for selcting our product for your home. We hope that you are completely satisÿed with your purchase.Please read below instructions carefully before installing new faucet. 8" Two handle widesperad lavatory faucet with pop-up drain Model Number: S8228-8 Cold Water...
  • Page 2 Faucet Installation 1.Place the spout into center hole(The hole diameter 2.Insert the valve body assembly with the hot supply should be 1-3/8”) of the sink.Under sink,secure ÿrmly label is on the left (hot) side.Hold the body in the proper to sink with rubber washer(17),metal washer(16) and position.Assemble metal washer(10) and mounting nut(11) nut(15).
  • Page 3 Pop-up Drain Installation 5A:Pop up Drain Installation: OR:Insert body into sink. If you wish to use silicone as a.Remove ˜ange(01),rubber wahser(02),from the a seal, remove the top gasket and apply silicone to pop-up assembly. underside of drain body. b.Put the pipe body(04) into the sink hole,install the rubber wahser(02) and the ˜ange(01),tighten the mounting nut(03) use wrench.
  • Page 4 Trouble-Shooting If you have followed the instructions carefully and your faucet still does not work properly,take the following corrective steps: PROBLEM CAUSE ACTION Unscrew aerator with aerator Aerator drips or has inconsistent Aerator may be dirty or not key and clean out debris water ˜ow pattern seated properly Washers may be compromised...

Table of Contents