LockTech AccuReader HYD13 Instructions

X234 Harley
www.locktech.biz
accureader@locktech.biz
Thank you for purchasing the AccuReader by
LockTech wafer reading system. This system will
allow you to read the X234 ignition completely and
accurately without the removal of the ignition.
Following a few simple steps it takes only minutes to
read the depths for each cut in each position for a
complete key.
The AccuReader works on the process of
elimination to decipher the correct depths of the lock.
By checking the deepest cut first you eliminate what
the cuts are not. Therefore it is essential to always
read depth slide #4 first.
Please take the time to familiarize yourself
with the tools and verify all pieces are accounted for
from the list of contents below:
Package Contents:
1-AccuReader key
1-insertion/release slide
1-depth slide #4
1-depth slide #3
1-depth slide #2
1-Tube storage container
1-Tube Cap
by
USING THE ACCU-READER
1) Always thoroughly clean the lock with a electronics
safe cleaner to free any potentially stuck wafers.
2) Use the alignment holes through the AccuReader
key to assist in judging the distance from one wafer
position to the next.
3) Place the insertion/release slide in the slot on the
AccuReader key. Fully insert the AccuReader key into
the keyway and remove the slide. The AccuReader
key is now ready to read the space #5 position. (Note:
If the AccuReader fails to trap a wafer flip the
AccuReader over and reinsert).
4) Always start reading with the #4 depth slide tool,
then proceed to #3, then #2 (if necessary). Fully
insert the depth slide into the AccuReader key. The
alignment mark on the depth slide will line up with the
(Y) Yes mark or it will line up with the (N) No mark.
a) If the #4 depth slide lines up with the Y then
the depth for the #5 wafer is a 4. If the depth slide
lines up with a N, then you must proceed to the #3
depth slide.
b) If the #3 depth slide lines up with the Y then
the depth for the #5 wafer is a 3. If the depth slide
lines up with a N, then you must proceed to the #2
depth slide.
c) If the #2 depth slide lines up with the Y then
the depth for the #5 wafer is a 2. If the depth slide
lines up with a N, then the depth for wafer #5 is a 1.
d) Repeat steps a through c for each wafer
position until you have recorded the depth for wafer
positions 5-1.
e) You now have recorded all the positions to
make a complete key.