Advertisement
2.
Slide two additional T-Bolts into the bottom T-Slot of the
extruded fence, place the T-Bolt through the open slot in the
bracket and assemble the washer and knob.
NOTE: The fence has a 24" laser etched scale and can be
used on either side of the workpiece as required. Simply
reverse the fence.
Figure 7
Knob
Washer
Etched
Scale
3.
Position the fence perpendicular to the drill press table
T-Track, use a tape measure to make sure each end of the
fence is the same distance from the end of the table.
Figure 8
4.
When in position, tighten all four knobs of the brackets.
Flip Stop
Refer to Figure 9 and 10
The POWERTEC 71367 3" fence flip stops are extremely
versatile and quickly convert from inboard to outboard
position for a variety of applications. In addition, the flip
arm can be moved from right to left to match your feed
direction requirements.
• Slide the T-Bolt on the bottom of the flip stop into the T-Slot on
the top of the fence. See Figure 10.
• In the inboard position, the stop works with the supplied multi
T-Track fence and functions as an easily adjustable stop.
• In the outboard position, the body rotates and the flip arm
moves out. In this position the stop can work with the supplied
multi T-Track fence and a 3/4" sacrificial wood board.
Open Slot in
Bottom T-Slot
Bracket
of Extruded
Fence
To Convert from Inboard to Outboard Position
Remove the knob and T-Bolt and rotate the stop body 180°.
Replace the knob and T-bolt. See Figure 9.
Figure 9
Knob
Stop Body
inboard
T-Bolt
Hold Down Clamps
Refer to Figure 10
Slide the T-Bolts on hold-down clamps into the upper table
T-Track slots and clamp as required.
Figure 10
Upper Table
T-Track Slot
Hold-Down
Clamp
TIPS
• Turn the feed handles on the drill press to makes sure they do
not interfere with the fence system. If needed, one or more of
the feed handles may need to be removed.
• Periodically check and make sure all knobs are tight
and secure.
• Clean the drill press table/fence system after each use:
-
Wipe the drill press table and vacuum all T-Slots in
the table and fence.
-
To prevent condensation and rust between the two
tables, DO NOT leave the drill press table mounted
on the drill press for long periods of time.
transition
Flip Stop
outboard
T-Slot
Advertisement
